BROWN SS-55
Light Brown finish for Stainless Steel
Orders/Questions 1-888-417-5214
Product Description
Brown SS-55 (formerly Rusty Rainbow SS) for stainless steel is a concentrated, rapid acting, chemical conversion liquid compound to develop a mostly brownish but at times, rainbow finish on stainless steel parts by immersion at room temperature. The product is a mildly acidic solution containing no chromates, sulfides, cyanides, caustic or phenols. It is recommened for decorative & aesthetic purposes.
Stainless Steel should be sanded prior application to help the patina penetrate.
ALWAYS wear a FULL FACE respirator with 'Acid Gas' cartridges when usng Brown SS-55. Recommended: outside application with adequate ventillation.
Brown SS-55 Procedures:
Brown SS-55 is a concentrated liquid for producing antique color tones on Stainless Steel at room temperature. Brown SS-55 is used primarily for decorative purposes to produce a light to medium-brown antique color finish.
Preparation:
Parts must be free of grease, alkalinity or acid when Brown SS-55 is applied. Parts must be thoroughly cleaned and deoxidized prior to blackening. Cleaner 104 is recommended for removing heavy oils and oxidation. Do not use petroleum degreasing solvents that leave a residue on the surface. Rinse thoroughly with over flowing cold water to remove residual cleaners and dust. It is important that alkaline cleaners are completely rinsed off prior to blackening.
IMPORTANT: Triple- S does NOT recommend using any sort of alcohol, solvent, acid or degreaser to clean parts prior to solution application. Cleaner 104 is a great cleaner to ready parts for Brown SS-55 or even a powdered cleaner like Ajax or Comet are recommended. Use with a Scotch Brite pad and medium scrubbing to prepare the part then thoroughly rinse with fresh water.
Application:
Brown SS-55 is to be used as is: No Dilution Necessary. A uniform brown finish will develop in a period of 10 to 60 seconds. Once the color you seek has developed, you can halt the process by dipping the piece in water. Neutralize the piece with a water & baking soda mixture and then seal if so desired.
Sand blast or sand metal with 80-100 grit sand paper. Clean the part with Cleaner 104. Rinse with over flowing cold water. Apply with a Scotch Brite pad and apply in a circular motion to help push the material into the metal. You could also immerse the parts in Brown SS-55 for Stainless Steel solution for 10 to 60 seconds. Agitate the parts to break air bubbles and to assure solution contact with all surfaces. You can also apply with a scotch brite pad and apply in a circular motion to help the material get into the metal. Plastic or plastic baskets should be used for small parts. Rinse thoroughly with over flowing cold water and dry the surface. We recommend using a heat source to dry teh peice so there is ZERO moisture when applying the sealer. Apply a sealer.
Comprehensive instructions can be found on the 'Data Sheet' -
printable version found in the top right (above the picture).
The information stated herein is based on information and tests we believe to be reliable. The accuracy or completeness thereof is not guaranteed. Since conditions of use are outside our control, user shall, before using, determine the suitability of the product for his intended use and user assumes all risk and liability in connection therewith.